Hi
I have a PowerVault MD3060e and although not stated if an external raid controller like a H800, H810 or H830 is supported by the unit I am able to see all the drives and create virtual disks but when I look in open manage and navigate to storage I notice I have an red cross on connector 1 relating to an unknown backplane. Connector 1 is fine and I am able to view the physical disks in the MD unit.
I have tested both controllers are performing correctly and I am able to load balance and when I fail over the controllers I still have full access to the virtual disks.
Can anyone offer any advice on how I can correct the connector 0 error
Regards
Dave