Hello, recently i got Dell MD3000 Dual controller storage, but it is actually locked and i can't get in by Dell Storage Manager. Previous ovner said that Storage stop working after he tried to update firmware but something go wrong.
I managed to connect via serial cable and upload firmware by startup menu (ctrl +b, selection 2, first NVSRAM, after full Firmware), but even after that i still can't connect to storage via storage manager (but i can connect via telnet).
Boot log (captured via putty connected to serial port):
-=<###>=-
Attaching interface lo0... done
Adding 9767 symbols for standalone.
Error
06/19/17-10:50:58 (GMT) (tRootTask): NOTE: I2C transaction returned 0x0423fe00
06/19/17-10:51:04 (GMT) (tRootTask): ERROR: ne1617Retry timeout
06/19/17-10:51:04 (GMT) (tRootTask): NOTE: I2C transaction returned 0x04223409
06/19/17-10:51:05 (GMT) (tRootTask): ERROR: ne1617Retry timeout
06/19/17-10:51:05 (GMT) (tRootTask): NOTE: I2C transaction returned 0x04229c09
06/19/17-10:51:07 (GMT) (tRootTask): ERROR: Could not reconstruct VPD on midplane EEPROMs
Reset, Power-Up Diagnostics - Loop 1 of 1
3600 Processor DRAM
01 Data lines Passed
02 Address lines Passed
3300 NVSRAM
01 Data lines Passed
5900 Ethernet 91c111 #1
01 Register read Passed
02 Register test Passed
3A00 NAND Flash
06 Bad Blocks Test Passed
2310 Application Accelerator Unit
01 AAU Register Test Passed
6D00 LSI SAS 1068 IOC--Base Board
01 IOC Register Read Test Passed
02 IOC Register Address Lines Test Passed
03 IOC Register Data Lines Test Passed
3900 Real-Time Clock
01 RT Clock Tick Passed
Diagnostic Manager exited normally.
Current date: 06/19/17 time: 10:51:23
Send <BREAK> for Service Interface or baud rate change
06/19/17-10:51:23 (GMT) (tRAID): NOTE: Set Powerup State
06/19/17-10:51:23 (GMT) (tRAID): NOTE: SOD Sequence is Normal, 0
06/19/17-10:51:23 (GMT) (tRAID): NOTE: Turning on tray summary fault LED
esmc0: LinkUp event
06/19/17-10:51:26 (GMT) (tNetCfgInit): NOTE: Acquiring network parameters for interface esmc0 using DHCP
06/19/17-10:51:29 (GMT) (tRAID): ERROR: ne1617Retry timeout
06/19/17-10:51:29 (GMT) (tRAID): NOTE: I2C transaction returned 0x04223409
06/19/17-10:51:31 (GMT) (tRAID): ERROR: ne1617Retry timeout
06/19/17-10:51:31 (GMT) (tRAID): NOTE: I2C transaction returned 0x04229c09
06/19/17-10:51:33 (GMT) (tRAID): NOTE: I2C transaction returned 0x04227d01
06/19/17-10:51:33 (GMT) (tRAID): NOTE: I2C transaction returned 0x04227d01
06/19/17-10:51:33 (GMT) (tRAID): NOTE: I2C transaction returned 0x04227d00
06/19/17-10:51:33 (GMT) (tRAID): NOTE: I2C transaction returned 0x04227d00
06/19/17-10:51:33 (GMT) (tRAID): NOTE: I2C transaction returned 0x04227d00
06/19/17-10:51:33 (GMT) (tRAID): NOTE: I2C transaction reporting disabled.
06/19/17-10:51:34 (GMT) (tRAID): NOTE: SYMBOL: SYMbolAPI registered.
06/19/17-10:51:34 (GMT) (tRAID): NOTE: lost persistent dq data because buffer was modified or size changed.
06/19/17-10:51:37 (GMT) (tNetCfgInit): NOTE: DHCP obtained a lease for interface esmc0
06/19/17-10:51:37 (GMT) (tNetCfgInit): NOTE: DHCP server name:
06/19/17-10:51:37 (GMT) (tNetCfgInit): NOTE: DHCP server: 192.168.46.1
06/19/17-10:51:37 (GMT) (tNetCfgInit): NOTE: Assigned IP address: 192.168.46.32
06/19/17-10:51:37 (GMT) (tNetCfgInit): NOTE: Assigned subnet mask: 255.255.255.0
06/19/17-10:51:37 (GMT) (tNetCfgInit): NOTE: Client IP routers:
06/19/17-10:51:37 (GMT) (tNetCfgInit): NOTE: 192.168.46.1
06/19/17-10:51:37 (GMT) (tNetCfgInit): NOTE: Client DNS name servers:
06/19/17-10:51:37 (GMT) (tNetCfgInit): NOTE: 192.168.47.100
06/19/17-10:51:37 (GMT) (tNetCfgInit): NOTE: 192.168.47.112
06/19/17-10:51:37 (GMT) (tNetCfgInit): WARN: **WARNING** The DHCP Server did not assign a permanent IP for esmc0.
06/19/17-10:51:37 (GMT) (tNetCfgInit): WARN: Network access to this controller may eventually fail.
06/19/17-10:51:37 (GMT) (tNetCfgInit): NOTE: Network Ready
06/19/17-10:51:38 (GMT) (tRAID): NOTE: Initiating Drive channel: ioc:0 bringup
06/19/17-10:51:40 (GMT) (tRAID): NOTE: IOC Firmware Version: 00-24-63-00
06/19/17-10:51:48 (GMT) (tSasEvtWkr): NOTE: sasIocPhyUp: chan:1 phy:0 prevNumActivePhys:2 numActivePhys:2
06/19/17-10:51:48 (GMT) (tSasEvtWkr): NOTE: sasIocPhyUp: chan:1 phy:1 prevNumActivePhys:2 numActivePhys:2
06/19/17-10:51:58 (GMT) (tRAID): NOTE: IonMgr: Drive Interface Enabled
06/19/17-10:51:58 (GMT) (tRAID): NOTE: SOD: Instantiation Phase Complete
06/19/17-10:51:58 (GMT) (tRAID): WARN: No attempt made to open Inter-Controller Communication Channels
06/19/17-10:51:58 (GMT) (tRAID): NOTE: Failing The Alternate Controller
06/19/17-10:51:58 (GMT) (tRAID): WARN: Alt Ctl Reboot:
Reboot CompID: 0x401
Reboot reason: 0x6
Reboot reason extra: 0x0
06/19/17-10:51:58 (GMT) (tRAID): NOTE: holding alt ctl in reset
06/19/17-10:51:58 (GMT) (tRAID): NOTE: LockMgr Role is Master
06/19/17-10:51:58 (GMT) (tRAID): WARN: FBM:validateSubModel: Exception - Alt controller not ready
06/19/17-10:51:58 (GMT) (tSasDiscCom): NOTE: SAS Discovery complete task spawned
06/19/17-10:51:58 (GMT) (fbmLockdownTask): WARN: Invalid Sub-Model ID, locking down
06/19/17-10:51:59 (GMT) (tRAID): NOTE: spmEarlyData: No data available
06/19/17-10:51:59 (GMT) (sasCheckExpanderSet): NOTE: Expander Firmware Version: 0116-e05c
06/19/17-10:51:59 (GMT) (sasCheckExpanderSet): NOTE: Expander SAS address: Hi = x500a0b84 Low = x5a122a10
-=<###>=-
Attaching interface lo0... done
Adding 9767 symbols for standalone.
Error
06/19/17-10:52:05 (GMT) (tRootTask): NOTE: I2C transaction returned 0x0423fe00
06/19/17-10:52:11 (GMT) (tRootTask): ERROR: ne1617Retry timeout
06/19/17-10:52:11 (GMT) (tRootTask): NOTE: I2C transaction returned 0x04223409
06/19/17-10:52:12 (GMT) (tRootTask): ERROR: ne1617Retry timeout
06/19/17-10:52:12 (GMT) (tRootTask): NOTE: I2C transaction returned 0x04229c09
06/19/17-10:52:14 (GMT) (tRootTask): ERROR: Could not reconstruct VPD on midplane EEPROMs
Current date: 06/19/17 time: 10:52:29
Send <BREAK> for Service Interface or baud rate change
06/19/17-10:52:28 (GMT) (tRAID): NOTE: SOD Sequence is Normal, 0
06/19/17-10:52:29 (GMT) (tRAID): NOTE: Turning on tray summary fault LED
06/19/17-10:52:29 (GMT) (tRAID): NOTE: Flashing tray summary fault LED
06/19/17-10:52:29 (GMT) (tRAID): WARN: Controller entering SubmodMis lockdown state...
esmc0: LinkUp event
06/19/17-10:52:32 (GMT) (tNetCfgInit): NOTE: Acquiring network parameters for interface esmc0 using DHCP
06/19/17-10:52:40 (GMT) (tNetCfgInit): NOTE: DHCP obtained a lease for interface esmc0
06/19/17-10:52:40 (GMT) (tNetCfgInit): NOTE: DHCP server name:
06/19/17-10:52:40 (GMT) (tNetCfgInit): NOTE: DHCP server: 192.168.46.1
06/19/17-10:52:40 (GMT) (tNetCfgInit): NOTE: Assigned IP address: 192.168.46.32
06/19/17-10:52:40 (GMT) (tNetCfgInit): NOTE: Assigned subnet mask: 255.255.255.0
06/19/17-10:52:40 (GMT) (tNetCfgInit): NOTE: Client IP routers:
06/19/17-10:52:40 (GMT) (tNetCfgInit): NOTE: 192.168.46.1
06/19/17-10:52:40 (GMT) (tNetCfgInit): NOTE: Client DNS name servers:
06/19/17-10:52:40 (GMT) (tNetCfgInit): NOTE: 192.168.47.100
06/19/17-10:52:40 (GMT) (tNetCfgInit): NOTE: 192.168.47.112
06/19/17-10:52:40 (GMT) (tNetCfgInit): WARN: **WARNING** The DHCP Server did not assign a permanent IP for esmc0.
06/19/17-10:52:40 (GMT) (tNetCfgInit): WARN: Network access to this controller may eventually fail.
06/19/17-10:52:40 (GMT) (tNetCfgInit): NOTE: Network Ready
So, what i can do now?