Hi
We have two MD36 chassis, that is taken out of service, the first one has two MD3600i controllers og the other one has no controllers.
We would like to use these in our vmware test setup instead, but have problems with using the chassis with only one controller.
In the deployment Guide from Dell, it states that it is possible to run with only one MD3600i controller in the chassis, but we cannot get them to accept that the other controller is removed.
We tried a sysWipe from the serial console, with no luck.
Do any one know how to reset the system to factory (md3600i controller board), to enable it to run as a stand alone controller.
Any help is dearly appreciated.
/Steven